LED Under Cabinet Lighting has never been so easy to install.
Figure 1: Easy to install LED strip lights have a female receptacle at the end to accommodate either a connector, or the plug on the transformer.
Figure 2: One strip to strip wire connector is included with each strip. This connector is used when you want to have space between the strips. It allows for about 8". If you need to space the strips farther apart, you simply splice and add more wire in between.
Figure 3 and 4: One barrel pin type is also included with each strip. Use this connector when you want to install the strips side by side.
Transformer has a pin connector which you simply insert into the end of the strip and plug it into an outlet.
ETL Listed transformer has a barrel pin connector which simply plugs in to the end of the strip and then plugs into an outlet. Each transformer will power up to three strips. Input voltage 100-240VAC. Dimensions
3 3/4" x 2" x 1 1/4 ". 3 1/2' lead wires at both ends.
Each strip comes with a hardware package which includes one wired strip to strip connector, one barrel pin connector, two mounting brackets with screws, and two magnetic clips with double sided tape. Yes, the magnetic clips stick to the back of the strip. Double sided tape affixes to the surface.
Input Voltage: 12VDC
Power Consumption: 9W @ .6M; 800mA per strip
LEDS: 36 ea Epistar 5050 SMD LEDs
Lumens: 480 WW, 540 DL
View Angle: 120 degrees
Operating Temperature: -20C to 40C (-4 F to 104 F)